Integral Waterproofing Liquid Admixture


Integral Waterproofing Liquid Admixture is a formulation of special epoxy and polyamide resin. It is a two-part solvent epoxy protective and decorative coating for steel and concrete substrates. It provides protection from weathering and abrasion.

Uses:

To protect steel and concrete surfaces. To penetration, abrasion and chemical attack.

enhance resistance to oil, grease, water

Advantages:

> easy to apply by brush, roller or spray.

> project and decorates.

> to enhance resistance to oil, grease, water penetration, abrasion and chemical attack.

> strong and hard wearing surface.

> easy to clean, hygienic, seamless floor.

> excellent adhesion and maximum protection.

> cost-effective protective coating ' can be applied floor and walls

> can be used for rebars-does not affect bonding of concrete with steel.



http://www.applechemie.com

Comments

Post a Comment

Popular posts from this blog

MARKET FORMS OF STEEL

Following are the standard shapes in which the rolled steel sections are available in the market- 1. Angle sections- The Angle section may be equal legs or unequal legs. The equal angle sections are available in sizes varying from 20 mm x 20 mm x 3 mm to 200 mm x 200 mm x 25 mm. The corresponding weight per meter length are respectively 9 N and 736 N. The unequal angle sections are available in sizes varying from 30 mm x 20 mm x 3 mm to 200 mm x 150 mm x 18 mm. The corresponding weight per meter length are respectively 11 N and 469 N. The angle section extensively used in the structural steel work especially in the construction of steel roof trusses and filler joist floors. 2. Channel Section- The channel section consist of a web with two equal flanges. A channel section is designated by the height of web and width of flange. These sections are available in sizes varying from 100 mm x 45 mm to 400 mm x 100 mm. The corresponding weights per metre length are respectively 5
Read more

Materials are used for road construction

Image
Road consist of basically 4 layers: Sub-grade: The sub-grade material should be clean and free from organic matter and should be able to be compacted by roller, to form stable sub-base. The material should have the following characteristics: ·          Well graded, uniformity coefficient (D60/D10) should not be less than 3. ·          Fraction passing sieve #200 shall not be greater than 2/3rd of the fraction passing sieve #40. ·          Should have a L.L not greater than 25%. ·          P.I not greater than 6 ·          CBR should not be less than 25. ·          In coarse grain, aggregate retained by #10 sieve, %age of wear shall not be greater than 5%. ·          The maximum dia of any particle shall not be greater than 2/3rd of the layer thickness of sub-base Typical particle size distribution for the sub-base (granular) which will the meet strength requirements are: 2.Sub-base Course: ·          It is layer of granular mat
Read more

GREEN BUILDING PRODUCTS

Image
GREEN BUILDING PRODUCTS “GO GREEN GO CLEAN” •       We are committed to protect environment & we are a part of the global mission called "GREEN WORLD" and also providing innovative construction chemicals for Green Building. •       We are also the part of IGBC (Indian Green Building Council) •       Green building products: Green building products are composed of renewable resources and are environmentally responsible because impacts are considered over the life of the product. •       Overall material/product selection criteria: §   Resource efficiency §   Indoor air quality §   Energy efficiency §   Water conservation §   Affordability •       Our green building products meets the above maximum selection criteria as enumerated below: §   Environmentally friendly and sustainable construction chemicals are designed. §   Products are non-toxic and organic. §   During the process, air Pollution is minimum, waste reduction, Embodied Ener
Read more